Ross Synergy 100, Руководство по установке, Страница: 82 / 246

4–8 • Preliminary Video Installation Synergy 100 Installation Guide (v16.10-S100)
Connecting and Verifying Outputs
This section covers the following topics:
• Output Connection
• Output Verification
Output Connection
Using the data from the previous output chart, connect your outputs to the desired destinations. Use
cabling and connecting techniques in accordance with good engineering practice.
Output Verification
For verification of your outputs, ensure that some form of monitoring is available at the destination of
each specific output. The destination device itself may be a monitor, however, if the destination is a
VTR or a routing switcher, ensure that you can monitor the input signal to the specific device.
Note The optional Clean Feed output is software configurable using the
menu.
The Preview Overlay signal appears on both PV outputs.
Output Verification
Output to Verify Verification Method
PGM 1
Switch between inputs on PGM bus.
PGM 2
Switch between inputs on PGM bus.
PV 1
Switch between inputs on PST bus.
PV 2
Switch between inputs on PST bus.
AUX 3 - 10
On a Dedicated Remote Aux Panel , press button 1 , then switch between
all subsequent inputs on the Aux panel.
AUX 3 - 10
On the Assignable Remote Aux Panel , assign the Aux output number,
press button 1 , then switch between all subsequent inputs on the Aux
panel.
CLEAN
Output depends on clean feed point of origin. Refer to the section
“
Setting Up Outputs ” on page 8–4 for instructions.