Ross Synergy 100, Руководство по установке, Страница: 60 / 246

2–26 • Installation Synergy 100 Installation Guide (v16.10-S100)
6. Follow the instructions on the control panel’s display and wait for the upgrade process to
complete.
7. Turn off the frame.
8. Move DIP Switch 4 ,
SW8
(on the Frame CPU Board ) to the
Down
position.
9. Power on the frame.
This completes the procedure for upgrading system software. Please continue to the section
“
Restoring Registers ” on page 2-27.
Using a USB Key
Use the following procedure to initiate the software upgrade from a USB key:
1. Power off the Synergy frame.
2. Move the Software Upgrade jumper ( DIP Switch 4 , SW8 on the Frame CPU Board )
to the Up position.
Software Upgrade Jumper
3. Power on the frame.
4. At this time, a message will appear in the four-character displays, asking you if you have
saved your memories.
• If you have not, press the
1
(UP arrow) button to display the word “
Quit
” and press
SEL
.This will cause the frame to boot without upgrading the software, and give you
a chance to save your setups to a USB key. Refer to the section “ System Backup ”
on page 2-24 for instructions.
• If you have saved your setups to a USB key, press
SEL
under the “
Cont
” prompt
and continue with the upgrade.
5. Insert the USB key containing the Synergy 100 software into the USB port of the
Synergy 100 switcher. You must wait 5 seconds after inserting the USB key into the
USB port before you can proceed to the next step.
6. Follow the instructions on the control panel’s display and wait for the upgrade process to
complete.
7. Turn off the frame.
8. Move DIP Switch 4 ,
SW8
(on the Frame CPU Board ) to the
Down
position.
Note You must have the USB Removable Media Drive option installed in
order to use a USB key for software upgrades.
Caution
Observe all static discharge precautions throughout this procedure.
Rear of Frame
Front of Board
Frame CPU Board
WATCH
DOG
RESET DIP SW1 DIP SW3 DIP SW2 DIP SW4
SW8