Ross Synergy 100, Руководство по установке, Страница: 119 / 246

Synergy 100 Installation Guide (v16.10-S100) Communication Setup • 7–19
Yamaha DM1000
The Synergy 1 frame connects to the Yamaha DM1000 via the MIDIator Systems MS-124W
converter box, using a 9-pin, D-type, Male RS-232 NULL modem cable from the frame’s Peripheral
port (1-2) to the MIDI box’s 25-pin to 9-pin adapter cable. The MIDI converter box is then connected
to the Yamaha DM1000 audio mixer.
The MIDI box uses two cables, one for output and one for input, to connect to the audio mixer.
• The MIDI box’s
In
port connects to the
MIDI OUT
port of the Yamaha DM1000 mixer.
• Any one of the MIDI box’s four
Out
ports can be connected to
MIDI IN
port of the
Yamaha DM1000.
Please note the following important information regarding the Yamaha DM1000 audio mixer:
• Baud rate: 38400, Parity: none, Data bits: 8, Stop bit: 1.
• The following pin-outs are required for the NULL modem cable:
n/c = Not connected
Synergy-to-MIDIator MS-124 Converter Wiring Chart
Synergy 1 Frame MIDIator MS-124 Converter
Peripheral 1-2
Connector Male
Signal Adapter Cable
Connector Male
Signal
1 n/c n/c
2 Tx → 3 Rx
3 Rx → 2 Tx
4 n/c n/c
5 Ground
→
5 Ground
6 n/c n/c
7 n/c n/c
8 n/c n/c
9 n/c
Note
For RS-232 cables, only pins 2, 3, and 5 should be connected. All other
pins must be disconnected.
Important
It is recommended that you use Peripheral Port 2 for controlling a
Yamaha DM1000, as true RS-232 is only available on Peripheral Port
2 . However, you can connect an audio board using RS-232 protocol to
Peripheral Port 1 if the
Protocol
heading is set to
RS-422
, and an
RS-422-to-RS-232 converter is used.