Ross Synergy 100, Руководство по установке, Страница: 91 / 246

Synergy 100 Installation Guide (v16.10-S100) BNC Configuration and Check • 6–3
Setting Up BNC Inputs
In Chapter 4, you connected your physical inputs, including reference, primary, and alpha inputs. In
this section, you will
configure each physical BNC input using the Inputs Menu on the Preview
Overlay . Ensure that you have completed your Input Worksheet . Refer to section “ Input
Worksheet ” on page 4–2 for instructions.
The following topics are discussed in this section:
• Setting Up BNC Types
• Setting Up Tallies
• Setting Up Auto Keys
• Setting Up Panel Buttons
Setting Up BNC Types
The Inputs Menu allows you to associate physical BNC connectors with input types . These
associations play important roles throughout the system, particularly with regard to filtering
subsequent BNC setup menus based on specific input types.
Use the following procedure to set your inputs:
1. Navigate to the Inputs Menu as follows:
• Press
MENU
to display the Main Menu on the Preview Overlay .
• Press
1. Inputs
to display the Inputs Menu .
Inputs Menu
Important
Before you begin the configuration process, ensure that the
Installation Enable Jumper ( DIP Switch 4 , SW7 on the Frame
CPU Board ) is in the Down position. This position allows all
installation settings to be changed without restriction. Refer to the
section “
Frame Jumpers and Switches ” on page 2–20 for details.
Note During the procedure, refer to the Input Type column in your Input
Worksheet . These “types” will be entered on the BNC Type Menu for
each input connected to the frame.
Inputs
0. Inputs
1. Panel
2. Tally
3. Audio
MENU
Exit 100
Previous 10
Down 1
Up SEL
Accept