Ross Synergy 100, Руководство по установке, Страница: 114 / 246

7–14 • Communication Setup Synergy 100 Installation Guide (v16.10-S100)
5. Select the baud rate for the Audio Mixer you have connected to the port as follows:
• Press
3. Baud
.
• Use the
UP ARROW
or
DOWN ARROW ( 1
or
10 )
buttons to select the baud rate
for the audio mixer. Refer to the documentation for your Audio Mixer to determine
the correct setting.
• Press the right
SEL
button to accept the new settings.
6. Select the parity for the Audio Mixer you have connected to the port as follows:
• Press
4. Parity
.
• Use the
UP ARROW
or
DOWN ARROW ( 1
or
10 )
buttons to select the parity for
the audio mixer. Refer to the documentation for your Audio Mixer to determine the
correct setting.
• Press the right
SEL
button to accept the new settings.
7. Select the communications protocol for the Audio Mixer you have connected to the port
as follows:
• Press
5. Protocol
.
• Use the
UP ARROW
or
DOWN ARROW ( 1
or
10 )
buttons to select the
communications protocol for the audio mixer. Refer to the Yamaha documentation
for your Audio Mixer to determine the correct setting.
• Press the right
SEL
button to accept the new settings.
8. Select the converter you want to use for communicating with the Audio Mixer as
follows:
• Press 9. Converter .
• Use the
UP ARROW
or
DOWN ARROW ( 1
or
10 )
buttons to select the type of
converter, if any, that you are using. There are two choices:
~
None
— Use this option if you are not using a converter.
~
MIDIator
— Use this option if you are using a MIDIator converter.
• Press the right
SEL
button to accept the new settings.
9. Press
MENU
to display the Installation Change Screen .
Note The baud rate and parity for most Remote Audio Mixers should
already be correctly set. Use these controls only if required.
Important True RS-232 is only available on Peripheral Port 2 . However, you
can connect an audio board using RS-232 protocol to Peripheral Port
1 if the Protocol heading is set to RS-422 , and an RS-422-to-RS-232
converter is used.
Note If you are using a Yamaha 01V96 audio board or a Yamaha DM1000
audio board, the
MIDIator MS-124W converter box is required to
connect the mixer to the Synergy switcher. This converter is not
required when interfacing with the Yamaha 01V, but can be used, if
desired.