Ross Synergy 100, Руководство по установке, Страница: 107 / 246

Synergy 100 Installation Guide (v16.10-S100) Communication Setup • 7–7
2. Select the peripheral port that is connected to the editor as follows:
• Press
0. Port
.
• Use the
UP ARROW
or
DOWN ARROW ( 1
or
10 )
buttons to select the
Editor
peripheral port.
• Press the right
SEL
button to accept the new settings.
3. Select the device you want to assign to the editor communications port as follows:
• Press
2. Device
.
• Use the
UP ARROW
or
DOWN ARROW ( 1
or
10 )
buttons to select the device
protocol. You can select between the following:
~
None
— Use this option to not assign an editor to the selected port.
~
GVG100
— Use this option to assign an editor to the Editor port using the
GVG 100 Editor protocol.
~
GVG200
— Use this option to assign an editor to the Editor port using the
GVG 200 Editor protocol.
~
GVG4000
— Use this option to assign an editor to the Editor port using the
GVG 4000 Editor protocol.
• Press the right
SEL
button to accept the new settings.
4. Select the baud rate for the editor you have connected to the port as follows:
• Press
3. Baud
.
• Use the
UP ARROW
or
DOWN ARROW ( 1
or
10 )
buttons to select the baud rate
for the editor. Refer to the Installation Manual for your editor to determine the
correct setting. You can select between the following:
~
9600
~
19200
~
38400
~
57600
~
115200
• Press the right
SEL
button to accept the new settings.
5. Select the parity for the editor you have connected to the port as follows:
• Press
4. Parity
.
• Use the UP ARROW or DOWN ARROW ( 1 or 10 ) buttons to select the parity for
editor. Refer to your editor documentation for the parity for your device.
• Press the right
SEL
button to accept the new settings.
Operating
Tip
Editor is greyed out in the 1. Type heading to indicate that an editor
is the only type of device that can be used in the Editor port.