Ross Synergy 100, Руководство по установке, Страница: 182 / 246

9–12 • Completing Setup Synergy 100 Installation Guide (v16.10-S100)
6. If you wish to recall only individual 3D wipes , press
5. Recall Indiv 3D Wipe
to
display the Recall Indiv 3D Wipe Menu .
Recall Indiv 3D Wipe Menu
• Use the HUE knob in the Mattes Group to select the 3D wipe effect from the
storage device that you want to recall.
Note that the wipe location at the To Switcher heading changes in accordance with
the selection at the From Disk heading.
• Use the SAT knob in the Mattes Group to recall the 3D wipe effect to a different
location than is currently selected.
~
Scroll to the desired location.
~ Press SEL in the System Control Group . The wipe effect is recalled from the
file STSEQXX.SEQ , where XX is the wipe number from 00 to 99.
7. During the recalling process, and depending on the registers being recalled, the
following menu (or a variation thereof) is displayed on your preview monitor:
Message Received During Recall
This menu follows the progress of your recalling procedure, and gives you the
opportunity to cancel the operation, if desired.
8. When the transfer is complete, eject the storage device from the switcher.
This completes the procedure for recalling your engineering and switcher setups.
Caution
Do NOT remove the floppy disk or USB key from the switcher before
the LED on the floppy drive or USB port goes out. Doing so may
destroy the data on your floppy disk or USB key, as well as the data on
the next one you insert into the switcher.
Recall Indiv 3D Wipe
From Disk : Seq 00
To Switcher : PageRoll
ShockWve
Seq 01
Use HUE or SAT to scroll list and the System
Control SEL to accept.
Recall All
Memory Transfer: 1% Complete
100
Cancel