Ross Synergy 100, Руководство по установке, Страница: 129 / 246

Synergy 100 Installation Guide (v16.10-S100) Communication Setup • 7–29
• Press the right
SEL
button to accept the new settings.
3. Assign a peripheral port to Serial Tally as follows:
• Press
1. Type
.
• Use the
UP ARROW
or
DOWN ARROW ( 1
or
10 )
buttons to select
Ser. Tally
.
• Press the right
SEL
button to accept the new settings.
4. Select the device you want to assign to the serial tally communications port as follows:
• Press
2. Device
.
• Use the
UP ARROW
or
DOWN ARROW ( 1
or
10 )
buttons to select the
particular protocol that the serial tally equipment is using. You can choose between
the following:
~
None
— Use this option to not assign a communication protocol to the serial
tally interface device connected to the selected port.
~
Contrib
— Use this option to assign the Contribution Serial Tally Protocol
to communicate with a serial tally interface device.
~
L.A.S.T.
— Use this option to assign the Look Ahead Serial Tally Protocol to
communicate with a serial tally interface device.
• Press the right
SEL
button to accept the new settings.
5. Select the baud rate for the serial tally interface device you have connected to the port as
follows:
• Press
3. Baud
.
• Use the
UP ARROW
or
DOWN ARROW ( 1
or
10 )
buttons to select the baud rate
for the serial tally interface device. Refer to the Installation Manual for your device
to determine the correct setting.
• Press the right
SEL
button to accept the new settings.
6. Select the parity for the serial tally interface device you have connected to the port as
follows:
• Press
4. Parity
.
• Use the UP ARROW or DOWN ARROW ( 1 or 10 ) buttons to select the parity for
the serial tally interface device. Refer to the Installation Manual for your device to
determine the correct setting.
• Press the right
SEL
button to accept the new settings.
7. Select the communications protocol for the serial tally interface device you have
connected to the port as follows:
• Press
5. Protocol
.
• Use the UP ARROW or DOWN ARROW ( 1 or 10 ) buttons to select the
communications protocol for the serial tally interface device. Refer to the
Installation Manual for your device to determine the correct setting. You can
choose between the following:
~
RS-232
— Use this option if the device uses the RS-232 communications
protocol.
Operating
Tip
When menu item 2. Device is set to L.A.S.T. , menu item 8. Option
changes to Delay and is greyed out.