Ross Synergy 100, Руководство по установке, Страница: 71 / 246

Synergy 100 Installation Guide (v16.10-S100) Preliminary Cabling and Check • 3–5
Power Up
Powering up the switcher causes the system to restore the previous condition that existed prior to
power down. In the absence of a valid condition, a “reset” condition is presented, with the BLACK
crosspoint selected on all buses. The switcher’s memory contents are retained.
Use the following procedure to power up the system:
1. Ensure all power cables, including the control panel’s DC power supply cable, are
fastened and secure.
2. The frame power switch is located on the right-hand side of the electronics frame, inside
the front cover. Remove the front cover and turn on the POWER switch.
3. On the frame, ensure that the POWER ON LED is lit (on the front of the frame) and that
all power supply LEDs (on the rear of the frame) are lit green.
• If the FAN FAIL or POWER FAIL LEDs are lit (on the front of the frame), turn
the unit off and check all power connections.
• If any of the rear panel power supply LEDs are not lit, turn the unit off and check all
power connections.
• Turn the unit back on and recheck all LEDs. If a problem still exists, contact Ross
Video Technical Support.
This completes the procedure to power up the system.
Note
The order in which you power up the frame and control panel is not
important — either can be powered up first.