Ross Synergy 100, Руководство по установке, Страница: 206 / 246

10–20 • Appendix A. Specifications Synergy 100 Installation Guide (v16.10-S100)
Aux Panel Programming Mode Summary
The following table summarizes all normal, GPI and special diagnostic Aux panel programming
modes for new generation Remote Aux Panels for the S100
Aux Panel Programming Mode Button Assignment
Button/
LED
Normal
Mode
Program Mode
Bus Assignment
Program
Mode
GPI Offset
Program Mode
GPI Status
Power Up
Diagnostics
1 (Black) Select Xpt 1 Display/modify this panel’s rights
to Aux Bus 1 (Dedicated panels
only) (*6) Set GPI to group 1
(offset 0) (*1) GPI 8 Status (ON =
shorted to ground) Start Walking
LED Test (*3)
2 Select Xpt 2 Display/modify this panel’s rights
to Aux Bus 2 (Dedicated panels
only) (*6) Set GPI to group 2
(offset 1) (*1) GPI 7 Status (ON =
shorted to ground) Start Pushbutton
LED Test (*3)
3 Select Xpt 3 Display/modify this panel’s rights
to Aux Bus 3 (Dedicated panels
only) Set GPI to group 3
(offset 2) (*1) GPI 6 Status (ON =
shorted to ground) Start DUART
Test (*3) (*4)
4 Select Xpt 4 Display/modify this panel’s rights
to Aux Bus 4 (Dedicated panels
only) Set GPI to group 4
(offset 3) (*1) GPI 5 Status (ON =
shorted to ground) Start EEPROM
Test (*3)
5 Select Xpt 5 Display/modify this panel’s rights
to Aux Bus 5 (Dedicated panels
only) Set GPI to group 5
(offset 4) (*1) GPI 4 Status (ON =
shorted to ground)
6 Select Xpt 6 Display/modify this panel’s rights
to Aux Bus 6 (Dedicated panels
only) Set GPI to group 6
(offset 5) (*1) GPI 3 Status (ON =
shorted to ground)
7 Select Xpt 7 Display/modify this panel’s rights
to Aux Bus 7 (Dedicated panels
only) Set GPI to group 7
(offset 6) (*1) GPI 2 Status (ON =
shorted to ground)
8 Select Xpt 8 Display/modify this panel’s rights
to Aux Bus 8 (Dedicated panels
only) Set GPI to group 8
(offset 7) (*1) GPI 1 Status (ON =
shorted to ground)
9 Select Xpt 9 Display/modify this panel’s rights
to Aux Bus 9 (Dedicated panels
only) Switch to GPI
Program Mode –
GPI Status and
LED will start
flashing. Switch to GPI
Program Mode –
GPI Offset and LED
will stop flashing.
10 (Shift) Select Xpt 10 Display/modify this panel’s rights
to Aux Bus 10 (Dedicated panels
only) Xpt 10 to be used
as Shift button for
shifted Xpts when
lit. (*2) Xpt 10 to be used as
Shift button for
shifted Xpts when
lit. (*2) LED used in
EEPROM Test
ASSIGN 1
to 10
inclusive Select Aux Bus Display/modify this panel’s rights
to the respective 10 Aux Buses
(Assignable Panels only)
MLE PV Select MLE
Preview