Ross Synergy 100, Руководство по установке, Страница: 47 / 246

Synergy 100 Installation Guide (v16.10-S100) Installation • 2–13
2. In addition to the cut-out measurement, ensure that there is sufficient clearance under
the desktop for connectors and cables on the rear of the control panel. Approximately
four inches (10.16 cm) of clearance should be sufficient, as displayed in the following
figure.
Detail — Control Panel Connector Clearance Requirements
3. Install the control panel in your console. The tub drops into the cut-out from above and
rests on edge supports at the sides
4. Normally, fasteners are not required to hold the control panel in place. However, if your
installation requires it (particularly for remote trucks), you can attach the tub to the desk
using the optional mounting bracket assembly.
Detail — Optional Mounting Bracket Assembly
Operating
Tip
When measuring for the cutout, it is recommended that you place the
front lip of the panel within four inches (10.16 cm) of the console front
(as shown in the diagram “ Synergy 100 Control Panel Cutout
Dimensions ” on page 2-12). This placement is designed for the
convenience of the operator.
Note
The Synergy 100 control panel can simply be set on the desktop.
Minimum Cable Clearance
4.0" (10.16 cm)
Maximum Table
Thickness
1" (2.54 cm)
Total Depth
from Desktop
2" (5.08 cm)
A
NALOG 100/110
S
YNERGY
TALLY 1 TALLY 2
12V__
4A
-----
ROSS VIDEO LIMITED
MADE IN CANADA
Synergy 100
THIS CLASS A DEVICE COMPLIES WITH CANADIA
ICES-003 AND PART 15 OF THE FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING CONDITIONS:
(1) THIS DEVICE MAY NOT
CAUSE HARMFUL INTERFERENCE
AND,
(2) THIS DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED, INCLUDING
INTERFERENCE THAT MAY CAUSE
UNDESIRED OPERATION.
R
Self-tapping Wood Screws
(Qty. 14 supplied)
Optional Mounting
Bracket
1" Metal Stand-offs
(Qty. 4 supplied)
#8 - 32 Mounting Screws
(Qty. 4 supplied)
Desktop
Level