Ross Synergy 100, Руководство по установке, Страница: 168 / 246

8–34 • Additional Installation Setups Synergy 100 Installation Guide (v16.10-S100)
Setting Up GPI Outputs
The GPI Outputs Setup Menu is used to configure 12 GPI Outputs. During this setup, you will
select a GPI Output and identify the Polarity and Type of the outgoing GPI signals. All 12 ports are
provided on the
GPI I/O connector on the rear of the Synergy frame. Refer to the section “ Standard
GPI Connections ” on page 8-26 for wiring instructions.
The GPI Outputs can be triggered using the Effects Control buttons. Refer to the section
“ Personality Setup ” on page 8-15 for GPIO Mode configuration details.
Use the following procedure to configure a GPI Output:
1. Navigate to the GPIs Menu as follows:
• Press MENU to display the Main Menu .
• Press 3. GPIs to display the GPIs Menu .
GPIs Menu
2. Press 2. GPI Outputs to display the GPI Outputs Menu .
GPI Output Menu
3. Select an output GPI to configure as follows:
• Press 0. Output .
• Use the UP ARROW or DOWN ARROW ( 1 or 10 ) buttons to select a GPI
number between 1 and 12.
• Press the right SEL button to accept the new settings.
GPIs
0. Frame GPIs
1. Remote GPIs
MENU
Exit 100
Previous SEL
Accept 10
Down 1
Up
2. GPI Outputs
GPI Outputs
0. Output
1. Type GPI 1
Edge
2. Polarity
3. BNC Low
None
MENU
Exit 100
Previous SEL
Accept 10
Down
1
Up