Ross Synergy 100, Руководство по установке, Страница: 138 / 246

8–4 • Additional Installation Setups Synergy 100 Installation Guide (v16.10-S100)
Setting Up Outputs
Now that you have set up your inputs in the previous chapter, the next step is to configure the output
of the switcher. The
Outputs Menu allows you to configure five output parameters: Aspect Ratio,
Reference Delay, Clean Feed, Ancillary data, and Remote Aux Panels.
The following topics are discussed in this section:
• Aspect Ratio
• Reference Delay
• Clean Feed Setup
• Ancillary Data Setup
• Setting Up Remote Aux Panels
• Remote Aux Panel GPI Programming
• Field Dominance
Aspect Ratio
Use the following procedure to set the output aspect ratio:
1. Navigate to the Outputs Menu as follows:
• Press
MENU
to display the Main Menu on the Preview Overlay .
• Press
2. Outputs
to display the Outputs Menu .
Outputs Menu
2. Set the output aspect ratio as follows:
• Press
0. Aspect
.
• Toggle the 0. Aspect button to select a mode. You can choose between the
following:
~
4:3 — Setting the output aspect ratio to 4:3 automatically defines the aspect
ratio of all the inputs as 4:3.
~ 16:9 — Setting the output aspect ratio to 16:9 automatically defines all of the
inputs as 16:9.
• Press the right SEL button to accept the new settings.
Outputs
0. Aspect
1. Ref Dly 4:3
300
MENU
Exit 100
Previous SEL
Accept
10
Down
1
Up
2. Clean BeforeKeys
3. Ancillary data
4. RemAuxPrg Off
5. Fld Dom Field1