Ross Synergy 100, Руководство по установке, Страница: 220 / 246

12–4 • Appendix C. Diagnostics Synergy 100 Installation Guide (v16.10-S100)
• In the Mattes Group ,
up
or
down
appears in the display, depending on the status
of the button.
• In the System Control Group , a numerical value, which represents the actual
button number, appears in the display.
3. Press each button, as required.
This completes the procedure to test the buttons.
Lamp Test
The Lamp Test allows you to test the LEDs of large groups of buttons on the panel at the same time.
Use the following procedure to test the lamps:
1. Press a button within the section of pushbuttons that you want to test. The sections are as
follows:
• Preset bus crosspoints
• Program bus crosspoints
• Key bus crosspoints
• Transition area buttons
• Downstream Keyer buttons
• Effects Keyer buttons, including the Effects Control area to the left of the Effects
Keyer group
• The entire upper pattern board
2. This action causes the green LEDs in that section to turn on, followed by the red LEDs,
and then the orange LEDs. If the section does not contain all colors of LEDs, only the
available colors will be cycled through.
3. Press buttons in selected panel sections to test all lamps in those sections, as required.
This completes the panel diagnostic tests. To exit diagnostic mode, press all three SEL buttons at the
same time.