Ross Synergy 100, Руководство по установке, Страница: 144 / 246

8–10 • Additional Installation Setups Synergy 100 Installation Guide (v16.10-S100)
Use the following procedure to set up your Remote Aux Panels:
1. As required, refer to your Output Worksheet (located in the the section “ Output
Connection ” on page 4-8) to verify the destinations and functions of all Aux Bus
outputs.
2. Navigate to the Outputs Menu as follows:
• Press
MENU
to display the Main Menu on the Preview Overlay .
• Press
2. Outputs
to display the Outputs Menu .
Outputs Menu
3. Toggle the 4. RemAuxPrg to enable Remote Aux Panel programming as follows:
• On — Use this option to enable the Remote Aux Panel programming mode. When
RemAuxPrg is set to On , the following actions occur:
~ All remote panels (both assignable and dedicated) are placed in “programming”
mode.
~ On all panels, the on-air LED flashes to alert you that programming mode is
now in effect.
•
Off
— Use this option to disable the Remote Aux Panel programming mode.
4. To assign the “rights” for an assignable panel, perform the following steps at each
assignable panel connected to the switcher. (For dedicated panels, skip down to the
next.)
• Ensure that the panel is in “programming” mode (with the on-air LED flashing).
• Press the ASSIGN ( 3 - 8 ) button that corresponds to the Aux Bus that you want to
program. Note that each press of the button toggles between two states:
~
On
— when a button is lit steadily, the associated Aux Bus is in “full access” or
“regular” mode. The Aux Bus can be selected and sources (crosspoints) can be
changed from both the remote Aux panel and the
local control panel.
~
Flashing
— when a button’s light is flashing, the associated Aux Bus is in
“follow” or “view only” mode. You can select the bus and follow what
Note
Off is the “default” setting for this feature. It is unnecessary to
physically return the setting to Off when programming is complete.
Simply exit the menu system. The Remote Aux Panel will
automatically exit programming mode and the
RemAuxPrg heading
will be set to Off .
Outputs
0. Aspect
1. Ref Dly 4:3
300
MENU
Exit 100
Previous SEL
Accept
10
Down
1
Up
2. Clean BeforeKeys
3. Ancillary data
4. RemAuxPrg Off
5. Fld Dom Field1