Ross Synergy 100, Руководство по установке, Страница: 121 / 246

Synergy 100 Installation Guide (v16.10-S100) Communication Setup • 7–21
MIDIator Interface Cable Specifications
The NULL modem cable that connects the MIDIator to the Peripheral Port on the Synergy 1 frame
has the following pinouts.
Assigning Audio Channels
The Audio Menu allows you to set the level that each audio channel will fade up to when faded in by
the switcher. A different level can be set for each of the 16 audio channels and you can assign up to
two audio sources to each BNC. Each source can be a channel or a group, with up to 3 channels per
group. Channels and groups that are assigned to BNC inputs, follow the BNC inputs to air on a
transition.
Use the following procedure to assign audio channels or groups to an input BNC:
1. Navigate to the Inputs Menu as follows:
• Press MENU to display the Main Menu .
• Press 1. Inputs to display the Inputs Menu .
Inputs Menu
Synergy-to-MIDIator MS-124 Converter Wiring Chart
Synergy 1 Frame MIDIator MS-124 Converter
Peripheral Port 1-2 Signal Cable Adapter Signal
1 n/c n/c
2 Rx
→
3 Tx
3 Tx → 2 Rx
4 n/c n/c
5 Ground → 5 Ground
6 n/c n/c
7 n/c n/c
8 n/c n/c
9 n/c n/c
Note
You must have an audio mixer properly connected to the Synergy 100
Switcher to be able to assign audio channels to Input BNCs. Refer to
the section “
Remote Audio Mixer Communication Setup ” on
page 7–11 for more information.
Inputs
0. Inputs
1. Panel
2. Tally
3. Audio
MENU
Exit 100
Previous 10
Down 1
Up SEL
Accept