Ross Synergy 100, Руководство по установке, Страница: 153 / 246

Synergy 100 Installation Guide (v16.10-S100) Additional Installation Setups • 8–19
Auto Recall Setup
If a memory is saved with the Effects Dissolve feature turned on, enabling the Auto Recall option in
the Personality Menu will automatically retrieve this setting when this same memory is recalled.
Use the following procedure to enable the Auto Recall option:
1. Navigate to the Personality Menu as follows:
• Press
MENU
to display the Main Menu .
• Press
6. Personality
to display the Personality Menu .
Personality Menu
2. Enable the Auto Recall option as follows:
• Press
4. AutoRcll
.
• Use the UP ARROW or DOWN ARROW ( 1 or 10 ) buttons to select On or Off as
follows:
~
On — Use this option to activate the Effects Dissolve button ( CNTR/EFF
D in the Effects Control group) when a memory you are recalling was
originally saved with the Effects Dissolve feature activated.
~ Off — Use this option to disable the Effects Dissolve button.You must now
press the Effects Dissolve button during memory recalls in order to “slew”
the switcher setup from its current setting to a new recalled setting.
• Press the right SEL button to accept the new settings.
3. Press
MENU
to display the Installation Change Screen .
4. Accept or cancel these changes as follows:
• Press
0. Confirm
to accept the changes.
• Press 1. Cancel to exit the menus safely, without making any changes. The system
returns to the previously stored settings.
This completes the procedure to enable the Auto Recall option.
GPI Mode
When the GPI Mode is Enabled , the GPI Outputs can be triggered from the Effects Control buttons.
Refer to the section “ Setting Up GPI Outputs ” on page 8-34 for GPI configuration details.
Personality - Synergy 100
0. Trans PV
1. DSK Drop On
Manual
MENU
Exit 100
Previous SEL
Accept 10
Down
1
Up
2. SleepTime 10 min
3. Menu Bttn Menu Only
4. AutoRcall On
5. GPIO Mode Disabled
6. Show Knob 0
7. Audio Cut
On