Newport MM4006, User Manual

Page: 66 / 411

MM4006 L o c a l Mode
HOME Preset
This feature is used to set the zero location according to the application's
needs. This parameter defines the value that will be loaded into the posi-
tion register when the motion device's home is found. The factory default
is zero, meaning that at the home location the position is zero. If, for
instance, this parameter is set to 12.3 mm, at the home location the con-
troller reports position 12.3 mm.
Do not set a value for the HOME Preset parameter that is outside the soft-
ware travel limits.
To change the HOME Preset parameter, press the MODIFY k e y. Use the
numeric keypad to enter a new value and then press VALID t o accept the
setting and return to the previous menu.
Press the UP k e y to advance to the next parameter.
Axis Setup
MODIFY
QUIT Q U I T ' YES Q U I T
WOW - V A L I D
SH — S e t home preset position.
Maximum Position
This parameter defines the positive (usually right) software travel limit. No
motion will be allowed to exceed this position in the positive direction.
CAUTION
Do not set a higher value for this than the default value, otherwise the
hardware limit switch will be tripped.
To change the positive software travel limit, press the MODIFY key. Use the
numeric keypad to enter a new value and then press VALID t o accept the
setting and return to the previous menu.
Press the k e y to advance to the next parameter.
Axis Setup
4., 4 • I
Or am Al
—÷ ! O
Foe
SR — S e t right travel limit.
(%)
Newport. 2 . 2 3
E13110181En1020 — 03/03