Newport MM4006, User Manual

Page: 57 / 411

MM4006 L o c a l Mode
Baud Rate
This parameter applies to RS-232-C and RS-485 interfaces. It sets the communi-
cation speed to he used on this port. The valid range is from 1200 to 115200.
The factory default is 9600 baud rate.
If the IEEE interface is used, ignore the selection by pressing the U P k e y
and advancing to the next parameter.
To set the baud rate from the General Setup menu, press U P u n t i l the
Baud Rate parameter appears on the display. Press MODIFY a n d then the
CHANGE k e y to select a new value. Press the VALID k e y to accept the
entry and return to the previous menu.
AWNS 4 . 1 1 4 4
W i s e g a r a l
Motor OFF
CHANGE
SETUP G E N .
VALID Q U I T Q U I T
UP
MODIFY
CMBxx — Set serial communication baud rate.
IEEE-488 or RS-485 Address
The IEEE-488 standard requires each connected instrument (device) to
have an address. The RS-485 used in Multi-Drop mode requires also an
address setting. If not used, ignore the selection by pressing the •*--UP
key and advancing to the next parameter. Default address is 2.
To change the existing address from t h e General Setup menu, press
UP u n t i l the IEEE Address appears on the display. Press MODIFY and
then enter the desired address on the keypad. Press the VALID k e y to
accept the entry and return to the previous menu.
Motor OFF
, I l i a viol=
. sat
! t i t isnis I
- s w i m =
VALID
SETUPti
QUIT
-* U P M O D I F Y
CMAxx — Set communication address.
ED110181En1020 — 03/03
2.14
N e w p o r t .