Head Adjuster B
Head Adjuster A
Slide
Slide
Magenta
Yellow
Yellow
Cyan
Cyan
Black
Black
Color Head
R E P 1 5 8 1
Model Name:
RJ–4100
R E P 1 5 8 1
Model Name:
RJ–4100
How to Adjust the Tilt and Depth of the Print Head (Color)
How to Adjust the Tilt and Depth of the Print Head (Color)
GO TO
TEST NO
Item
Replacement and Adjustment Procedure
1. Adjustment
and
Verification
279
4. Implement the “Capping Position Adjustment”.
(Refer to BAC2010)
5. Implement the “Head Rank Input”.
(Refer to BAC2040)
6. Implement the “Head Nozzle Verification”. (Refer to BAC2050)
7. Enter the rank of Black as it is and register the Color rank.
(Refer to BAC2040)
8. For “Ink Fill”, implement “Color” only.
After the inks have been filled, return to the previous menu.
9. Load media in the printer.
10. Implement the “Color Head Tilt Verification”.
(Refer to BAC2070)
This will run an adjustment print. Any offset between cyan
and yellow (Color Head Tilt) will be adjusted by Head
Adjuster B and any offset between Color and Black (depth
relative to Black) will be adjusted by Head Adjuster A.
11. Check the printing and move the carriage to the center.
If the cyan or yellow printing appears more forward than the
black printing, slide Head Adjuster A up and fasten it. If the
cyan or yellow printing is behind the black printing, slide
Head Adjuster A down and fasten it. When fastening the
Print Head, push it towards the taper of the Head Adjuster A
for depth and towards the taper of Adjuster B for tilt. (The
scales on Head Adjusters A and B represent a change of
about 0.1 mm per graduation.)
→
Continued on next page