CCW
CCW
CW
CW
Fourth line
Third line
Second line
First line
Paper eject
direction
Head Adjuster B
Slide
R E P 1 5 7 1
Model Name:
RJ–4100
R E P 1 5 7 1
Model Name:
RJ–4100
Adjust the Tilt of the Print Head (Black)
Adjust the Tilt of the Print Head (Black)
GO TO
TEST NO
Item
Replacement and Adjustment Procedure
1. Adjustment
and
Verification
274
4. Implement the “Capping Position Adjustment”. (Refer to BAC2010)
5. Implement the “Head Rank Input”.
(Refer to BAC2020)
6. Implement the “Head Nozzle Verification”.
(Refer to BAC2030)
7. Enter the rank of Black.
(Refer to BAC2040)
(The rank of Color will be registered as it is.)
8. For “Ink Fill”, implement “Black”.
(Refer to BAC2040)
After the ink has been filled, return to the previous level.
9. Load media in the printer.
10. Implement the “Black Head Tilt Verification”
This will make four single-pass, unidirectional printing runs. Use
Head Adjuster B to bring the first and second lines and the third
and fourth lines to approximately straight lines.
11. Check the printing and move the carriage to the center.
If the first line is offset to right relative to the second line, slide Head
Adjuster B down and fasten it. If the first line is offset to left relative
to the second line, slide Head Adjuster B up and fasten it. When
fastening the Print Head, push it towards the taper of the Head
Mount for depth and towards the taper of Adjuster B for tilt.
(The scale on Head Adjuster B represents a change of about 0.1
mm per graduation.)
12. Implement the “Black Head Tilt Verification”.
Repeat Steps 9 and 10 until the Black Head tilt disappears.
13. After completing the tilt adjustment, press [BACK] to return to the
previous menu.
→
Continued on next page