21
C O N 5 0 3 0
Model Name:
RJ–4100
C O N 5 0 3 0
Model Name:
RJ–4100
How to Replace the Cutter
How to Replace the Cutter
Depending on the type of roll media, paper dust may build up in the cutter groove
and on the cutter blade causing poor cutting. In such cases, the cutter should be
cleaned or replaced or the cutter groove should be cleaned.
The cutter is a consumable item. It it cuts badly, replace it.
Step 1
Switch off the power and bring the head to the center.
Step 2
Press the cutter down with your finger and rotate
the arm to the front. Take out the cutter.
Wipe the cutter blade with a dry cloth or replace
the cutter.
Step 3
Insert a new cutter in the hole in the head. As
you push down on the cutter, restore the cut-
ter arm over the cutter. The cutter will only go
in one way.
Cutter Arm
♦
There is a spring in the cutter mounting hole. Be careful not to lose it
when you replace the cutter.
CAUTION:
♦
The cutter blade is very hard and brittle. Be careful not to knock it or
drop it.
Step 4:
Return the head to the right end and switch on the power.
CAUTION:
♦
Since the life of the cutter depends on the type and thickness of the media
and the usage environment, it is recommended that a spare cutter be
procured.
Reference:
The auto-cut function cannot be used with some types of recommended
media.
If these types of media are used, a commercial cutter (such as OLFA 30B)
or scissors must be used for cutting.
The types of recommended media than cannot be cut by auto-cut are:
- Indoor cloth
- Yupo tac film
- Fire-resistant cloth
- Yupo film
- Outdoor cloth
CAUTION: