Head Adjuster A
Slide
Color Head
Yellow Black Cyan
R E P 1 5 7 2
Model Name:
RJ–4100
R E P 1 5 7 2
Model Name:
RJ–4100
Adjust the Tilt of the Print Head (Black)
Adjust the Tilt of the Print Head (Black)
GO TO
TEST NO
Item
Replacement and Adjustment Procedure
1. Adjustment
and
Verification
275
14. Implement the “Color Head Tilt Verification”. (Refer to
BAC2070)
This will run unidirectional printing with four colors. Here,
Head Adjuster A is used to adjust the depth of the Color
Head relative to the Black Head.
15. Check the printing and move the carriage to the center.
If the cyan or yellow printing appears is more forward than
the black printing, slide Head Adjuster A up and fasten it. If
the opposite applies, slide it down. When fastening the Print
Head, push it towards the taper of the Head Adjuster A for
depth and towards the taper of Adjuster B for tilt.
(The scales on Head Adjusters A and B represent a change
of about 0.1 mm per graduation.)
16. Implement the “Color Head Tilt Verification”.
Repeat Steps 13 and 14 until the positioning matches that of
the Black Head.
17. After completing the Black Head and Color Head positioning
adjustment, return to the previous menu level.
→
Continued on next page