Toshiba e-STUDIO GL-1010, Administrator'S Manual, Page: 172 / 427

150
GL-10x0
Administrator’s Guide
4 In the General area, enter the controller
SSID
.
5 Select the
Network Type
from the drop-down list.
6 If required, check
Use WEP Security
and
Set WEP key
. The
WEP Encryption
,
WEP Key
, and
Authentication
fields are enabled.
7 Select the type of
WEP Encryption
from the drop-down list box.
8 Enter the
WEP Key
as 5 or 13 sets of hex characters.
9 Select the
Authentication
mode from the drop-down list box.
10 Enter the identifier of the
Default Access Point
as 6 sets of hexadecimal
characters (Infrastructure network type only).
11 Enter the
Channel Number
(Ad Hoc network type only).
12 Select the
Transmit Power
from the drop-down list box.
13 Enter the number of
Data Retries
.
14 Enter the
Fragment Threshold
.
15 Enter the
RTS Threshold
.
16 Enter the
RTS Retry Limit
.
17 Click
Save
.
For more information on wireless NIC settings, consult the Cisco Aironet
Wireless LAN Adapters 340 and 350 Series Quick Start Guide .
Troubleshooting
Setting up Bluetooth Using a 3com USB Adapter
Install the optional Bluetooth USB Adapter by inserting the USB
connector into the USB port of the controller and rebooting the controller.
Troubleshooting
Problem Solution
Transfer rate says “No connection” Verify the access point is working
Verify SSID matches the access point
Verify WEP against the access point
There is a connection to the access
point and the printer is not visible on
the network Verify that the indicated settings on the Intel
card are all disabled. If it still fails, increase
the
Transmit Power Setting
.
There is a connection to the access
point, the authentication mode is
Open
System , and the printer is not visible
on the network
Verify that the indicated settings on the Intel
card are all disabled. If it still fails, make
sure that the WEP key of the client and AP
match.