Toshiba e-STUDIO GL-1010, Administrator'S Manual, Page: 145 / 427

GL-10x0
Administrator’s Guide 123
13 Enter the number of
Data Retries
.
14 Enter the
Fragment Threshold
.
15 Enter the
RTS Threshold
.
16 Enter the
RTS Retry Limit
.
17 Click
Save
.
For more information on wireless NIC settings, consult the Cisco
Aironet Wireless LAN Adapters 340 and 350 Series Quick Start Guide .
Troubleshooting
Setting Up the Firewall
The firewall provides protection for the controller and copier from
potential malicious access via the internet. It can be used to control
access to the controller and copier from unauthorized groups and
individuals within the company as well. The firewall controls access based
on IP addresses and IP address ranges. It can operate as an exclusive list
or an inclusive list or a combination. Be careful when defining complex
access rules that you do not work against your own intentions. The
firewall does not cross-check, nor does it provide a composite list of
allowed and denied IP addresses.
You can also deny access from certain MAC addresses, effectively
preventing certain machines from accessing the controller and copier.
To setup the firewall:
1
Log in as an administrator.
2 Click the
Administration
tab.
Problem Solution
Transfer rate says “No connection” Verify the access point is working
Transfer rate says “No connection” Verify SSID matches the access point
Transfer rate says “No connection” Verify WEP against the access point
There is a connection to the access point
but the printer is not visible on the network Verify that the indicated settings on the
Intel card are all disabled. If it still fails,
increase the
Transmit Power Setting
.
There is a connection to the access point,
the authentication mode is
Open System
,
and the printer is not visible on the
network
Verify that the indicated settings on the
Intel card are all disabled. If it still fails,
make sure that the
WEP key
of the client
and the Access Point (AP) match.