Toshiba e-STUDIO GL-1010, Administrator'S Manual, Page: 142 / 427

120
GL-10x0
Administrator’s Guide
1 Log in as an administrator.
2 On the Administration tab, click the
Setup
subtab.
3 Click the
Wireless Network
link. The Wireless Network page opens.
4 In the IPX/SPX area, click the
Protocol
drop-down list.
5 Select
Enable
to enable IPX/SPX.
6 Click the
Frame Type
drop-down list.
7 Select the appropriate setting.
8 Click
Save
.
Configuring TCP/IP Settings
If you are using the TCP/IP networking protocol for any wireless network
traffic involving the controller, you must enable the TCP/IP protocol on
the wireless NIC. The TCP/IP protocol is enabled by default. If you are not
using TCP/IP for any wireless network traffic, disabling the TCP/IP
protocol on the wireless NIC reduces overhead and improves efficiency.
1
Log in as an administrator.
2 On the Administration tab, click the
Setup
subtab.
3 Click the
Wireless Network
link. The Wireless Network page opens.
4 In the TCP/IP area, click the
IP Address Resolution
drop-down list.
5 Select either
Static IP
or
DHCP
.
Note: If
DHCP
is selected, the
IP Address
,
Subnet Mask
, and
Gateway Address
fields are not displayed.
6 Enter the
IP Address
,
Subnet Mask
, and
Gateway Address
if appropriate.
7 Enter the address of the
Primary DNS Server
.
8 Enter the address of a
Secondary DNS Server
.
9 Continue with the instructions in Configuring SMB Settings on
page 117.
Configuring Wireless DDNS
Dynamic DNS services allow a DHCP server to set the device Host Name
at the same time that it sets the IP address, gateway, and other
parameters. For those sites with large numbers of printers, DDNS allows
new printers to be configured automatically.
To configure DDNS:
1
Log in as an administrator.