Mitsubishi Electric MR-J4W2-0303B6, Instruction Manual

Page: 73 / 588

3. SIGNALS AND WIRING
3 - 34
(b) Off/on of the forced stop command (from controller) or EM2 (Forced stop 2)
When EM2 is turned off, all axes will be the operation status below.
POINT
In the torque control mode, the forced stop deceleration function is not available.
ON
ON
OFF
(Note 2)
Model speed command 0
and equal to or less than
zero speed
Disabled (ON)
Enabled (OFF)
OFF
Forced stop command
(from controller) or
EM2 (Forced stop 2)
MBR
(Electromagnetic
brake interlock)
ON (no alarm)
OFF (alarm)
Base circuit
(Energy supply to
the servo motor)
0 r/min
Servo motor speed
CALM (AND malfunction)
(Note 1)
Note 1. ON : Electromagnetic brake is not activated.
OFF: Electromagnetic brake is activated.
2. The model speed command is a speed command generated in the servo amplifier for forced stop
deceleration of the servo motor.
(c) Alarm occurrence
The operation status during an alarm is the same as section 3.7.
(d) Both main and control circuit power supplies off
When both main and control circuit power supplies are turned off, all axes will be the operation
status below.
MBR
(Electromagnetic
brake interlock)
(Note 2)
ON
OFF
Base circuit
ON
OFF
Alarm
([AL. 10 Undervoltage])
No alarm
Alarm
Approx. 10 ms
Dynamic brake
Dynamic brake
+ Electromagnetic brake
Electromagnetic brake
(Note 1)
Operation delay time of
the electromagnetic brake
Servo motor speed
ON
OFF
Main circuit
Control circuit Power supply
0 r/min
Note 1. Variable according to the operation status.
2. ON : Electromagnetic brake is not activated.
OFF: Electromagnetic brake is activated.