Mitsubishi Electric MR-J4W2-0303B6, Instruction Manual

Page: 393 / 588

17. APPLICATION OF FUNCTIONS
17 - 4
Compatibility
( : J4 new, : Equivalent to J3, : Not available)
Function Name MR-J4 series
MR-J3/MR-J3W series
(Note 8)
J4 mode
J3 compatibility
mode
Tough drive function
SEMI-F47 function A0 B0 (Note 15, 16)
Vibration tough drive A0 B0 (Note 15)
Instantaneous power failure tough
drive
A0 B0 (Note 15)
3-digit alarm display A0 A0 MR-J3W-_B
Diagnosis function
16 alarm histories supported A0 (Note 7) (Note 7)
Drive recorder function A0 B0 (Note 15)
Machine diagnosis function A0 B0 (Note 15)
SSCNET III A0
Controller SSCNET III/H A0
Home position return function A0 A0
Others
J4 mode/J3 compatibility mode
automatic identification (Note 11)
A0 A0
Power monitoring function A0 B0 (Note 15)
Note 1. The value is at the HG series servo motor driving.
2. The motor-less operation cannot be used in the fully closed loop control mode, linear servo motor control mode, or DD motor
control mode.
3. It is not available with MR-J4W3-_B servo amplifiers.
4. It is not available with the MR-J3W-_B, MR-J4W2-_B, and MR-J4W3-_B servo amplifiers.
5. It is not available with the MR-J4W2-_B and MR-J4W3-_B servo amplifiers.
6. The minute position detection method is available instead.
7. Alarm history will be saved up to six times.
8. The functions of the product with modified parts (GA) in the MR-J3-_B servo amplifiers are all covered by the J3 compatibility
mode of the MR-J4-_B servo amplifiers.
9. MR-J4W3-_B servo amplifiers do not support the fully closed loop control system.
10. For MR-J4 series, the robust filter and vibration tough drive are available instead.
11. The operation mode will be identified automatically at the first controller communication. You can change the operation mode
with the application "MR-J4(W)-B mode selection".
12. When MR-J4 is used as a replacement of MR-J3-_S, "Servo forced stop selection" in [Pr. PA04] will be "Disabled (_ 1 _ _)" in
the initial setting. Change the setting as necessary.
13. This is for MR-J4-_B servo amplifier. MR-J4-_B-RJ servo amplifier is compatible with two-wire type, four-wire type, and A/B/Z-
phase differential output method.
14. It is available with only MR-J4-_B-RJ servo amplifiers. It is not available with MR-J4-_B servo amplifiers.
15. This is available when the J3 extension function is enabled. Refer to section 17.1.9 for details.
16. For servo system controllers which are available with this, contact your local sales office.