LG-Ericsson ipldk-60, Feature Description And Operation Manual

Page: 308 / 512

ipLDK-60
Issue 2.0
Admin Programming Manual July, 2010
33
3.2.5 Station Attributes IV (PGM 114)
PGM 114 is one of four (4) program groups that assign general attributes to the station range. This PGM is associated with ISDN and DID services
and IP CO lines. Also, see PGMs 111, 112, and 113.
Procedure:
1. Press the [TRANS/PGM] button.
2. Dial 114.
3. Enter the appropriate Station Range.
4. Select the desired Flexible button from the chart below.
5. Enter the appropriate value.
6. Press the [Hold/Save] button.
PGM
114
Flex
Btn
Description Procedure Values
CLIP LCD
Display
1 If this parameter is ‘On’, the Calling Line Identification from the ISDN or the “From:”
header of SIP lines is displayed in the station’s LCD.
1 (On) 0 = Off
1 = On
COLP LCD
Display
2 If this parameter is ‘On’, the Connected Line Identification from the ISDN or the
“From:” header of SIP lines is displayed in the station’s LCD.
0 (Off) 0 = Off
1 = On
CLI / Redirect
Display
3 When a call is redirected by the ISDN or IP line, the station will display the original
Calling Line Id (CLI) or the Id of the line redirecting the call (RED).
0 (CLI) 0 = CLI
1 = Redirect
CLI MSG Wait 4 If this parameter is set to ‘On’, a CLI message is activated when the station does not
answer an incoming ISDN or IP CO line call.
0 (Off) 0 = Off
1 = On
EXT or ATD 5 When the CLIP Table Index (PGM 143, Flexible button 2) is 50, the system sends
either the station number (EXT) or the CO line Attendant station number as the Id.
0 (EXT) 0 = Extension
1 = Attendant
Keypad Facility 6 This parameter determines if digits dialed after the called is connected are sent as 0 (DTMF 0 = DTMF