Canon imageRUNNER ADVANCE C3330 Series, Service Manual

Page: 997 / 1225

SORTER (Service mode for delivery options) > ADJUST (Adjustment mode)
DW-CL 1 Setting downward curl prev mode: Fin-U1
Detail To set ON/OFF of downward curl prevention mode.
Set to 1 when a stacking failure occurs due to downward curl on the paper delivered to the Stack
Tray.
When upward curl prevention mode (UP-CL) is ON, the setting is disabled.
Use Case When downward curl occurs on the paper delivered to the Stack Tray, and papers are not stacked
accurately
Adj/Set/Operate Method Enter the setting value, and then press OK key.
Display/Adj/Set Range 0 to 1
0: OFF, 1: ON
Default Value 0
Related Service Mode SORTER> ADJUST> UP-CL
THC-CL 1 Setting heavy ppr curl prev mode: Fin-U1
Detail To set ON/OFF of heavy paper curl prevention mode.
Set 1 when upward curl occurs at the time of heavy paper delivery.
When either following condition is satisfied, the fall amount of the Stack Tray at the time of stack
delivery increases. In addition, the paper surface detection is performed at every sheet of paper,
not at every 5 sheets of paper.
- At the time of non-sort delivery on LDR size paper
- At the time of sort or staple sort delivery except small size paper stack delivery less than seven
sheets of paper
Use Case
- When upward curl occurs on the heavy paper delivered.
- When stack over detection is earlier than an assumption.
Adj/Set/Operate Method
Enter the setting value, and then press OK key.
Display/Adj/Set Range
0 to 1
0: OFF, 1: ON
Default Value
0
Supplement/Memo This mode is enabled in any of the following cases:
- When non-sort mode is selected for LDR paper
- When staple mode is selected
THC-PUSH 1 Setting heavy ppr out prev mode: Fin-U1
Detail To set ON/OFF of heavy paper push-out prevention mode.
Set to 1 when a sheet of paper on the stack tray delivered in the previous job is pushed out by a
sheet of heavy paper delivered in the following job.
When 1 is set and all the following conditions are satisfied, the stack tray descends temporarily
before a sheet of heavy paper is delivered on the processing tray: *
* Specified paper in the previous job is "plain paper".
* The first-delivered paper in the following job is "heavy paper".
* The length of the above-mentioned heavy paper is more than 216 mm.
The setting is disabled in non-collate mode.
Use Case When the already stacked paper is pushed out at the time of heavy paper delivery
Adj/Set/Operate Method Enter the setting value, and then press OK key.
Display/Adj/Set Range 0 to 1
0: OFF, 1: ON
Default Value 0
OFST-STC 1 [Not used]
8. Service Mode
985