Canon imageRUNNER ADVANCE C3330 Series, Service Manual

Page: 618 / 1225

730-A006-00 PDL communication error
Detection Description Response from PDL could not be detected.
Remedy
[Remedy] Perform the following in the order while checking whether the error is cleared.
1. Select "Settings/Registration> Function Settings> Printer> Printer Settings> Utility> Initialize
Printer", and execute PDL reset processing.
2. Reinstall the system software.
3. Replace the Main Controller PCB (UN05). (Unit of replacement: MAIN CONTROLLER PCB
ASSEMBLY)
730-A007-00 Mismatch of PDL version
Detection Description Version of the host machine control software and version of PDL control software were different.
Remedy [Remedy] Perform the following in the order while checking whether the error is cleared.
1. Reinstall the system software.
2. Replace the Main Controller PCB (UN05). (Unit of replacement: MAIN CONTROLLER PCB
ASSEMBLY)
730-B013-00 PDL embedded font error
Detection Description Font data was corrupted.
Remedy [Remedy] Perform the following in the order while checking whether the error is cleared.
1. Reinstall the system software.
2. Replace the Main Controller PCB (UN05). (Unit of replacement: MAIN CONTROLLER PCB
ASSEMBLY)
732-0001-04 Scanner communication error
Detection Description DDI-S communication error was detected.
Remedy [Related parts]
- Flat Cable between the Main Controller PCB (UN05/J33) and the Scanner Unit (Unit of
replacement: CABLE, FLAT)
- Scanner Unit (Unit of replacement: LASER SCANNER ASSEMBLY)
- Main Controller PCB (UN05) (Unit of replacement: MAIN CONTROLLER PCB ASSEMBLY)
[Remedy] Check/replace the related harness/cable, connector and parts.
732-0010-00 Scanner communication error
Detection Description DDI-S communication error (Vsync detection error) was detected.
Remedy [Related parts]
- Flat Cable between the Main Controller PCB (UN05/J33) and the Scanner Unit (Unit of
replacement: CABLE, FLAT)
- Scanner Unit (Unit of replacement: LASER SCANNER ASSEMBLY)
- Main Controller PCB (UN05) (Unit of replacement: MAIN CONTROLLER PCB ASSEMBLY)
[Remedy] Check/replace the related harness/cable, connector and parts.
733-0000-05 Printer communication error
Detection Description A communication error between the DC Controller PCB and the Main Controller PCB was detected
at startup.
Remedy [Related parts]
- Harness between the DC Controller PCB (UN04/J110) and the Main Controller PCB (UN05/J18)
(Unit of replacement: DDIP, CABLE)
- DC Controller PCB (UN04) (Unit of replacement: DC CONTROLLER PCB ASSEMBLY)
- Main Controller PCB (UN05) (Unit of replacement: MAIN CONTROLLER PCB ASSEMBLY)
[Remedy] Perform the following in the order while checking whether the error is cleared.
1. Check the harness between the DC Controller PCB and the Main Controller PCB.
2. Turn ON the power, and check if the initialization is executed at startup.
2-1. If the initialization is not executed, replace the DC Controller PCB.
2-2. If the initialization is executed, replace the Main Controller PCB.
[Reference] Before replacing the DC Controller PCB, back up the service mode data (approx. 2
min) and restore the backup data after the replacement so the data may be able to be protected.
- Backup: COPIER (LEVEL2)> FUNCTION> SYSTEM> DSRAMBUP
- Restoration: COPIER (LEVEL2)> FUNCTION> SYSTEM> DSRAMRES
7. Error/Jam/Alarm
606