Canon imageRUNNER ADVANCE C3330 Series, Service Manual

Page: 572 / 1225

535-8001-02 Swing Guide HP error
Detection Description The swing guide does not come off the Swing Guide HP Sensor although the Swing Guide Motor
has been driven for 3 seconds.
Remedy
STAPLE FIN-U1/BOOKLET FIN-U1
[Related parts]
- Harnesses and connectors from the Finisher Controller PCB to the Swing Guide HP Sensor
- Harnesses and connectors from the Finisher Controller PCB to the Swing Guide Motor
- Swing guide drive mechanism
- Swing Guide HP Sensor (PI105)
- Swing Guide Motor (M106)
- Finisher Controller PCB (PCB1)
[Remedy] Check/replace the corresponding harnesses/cables or connectors or the parts.
[Reference] When replacing the Finisher Controller PCB, refer to "Adjustment> Adjustment when
Replacing the Parts" in the Service Manual.
535-8002-02 Swing Guide HP error
Detection Description The Swing Guide HP Sensor does not detect the swing guide although the Swing Guide Motor
has been driven for 3 seconds.
Remedy STAPLE FIN-U1/BOOKLET FIN-U1
[Related parts]
- Harnesses and connectors from the Finisher Controller PCB to the Swing Guide HP Sensor
- Harnesses and connectors from the Finisher Controller PCB to the Swing Guide Motor
- Swing guide drive mechanism
- Swing Guide HP Sensor (PI105)
- Swing Guide Motor (M106)
- Finisher Controller PCB (PCB1)
[Remedy] Check/replace the corresponding harnesses/cables or connectors or the parts.
[Reference] When replacing the Finisher Controller PCB, refer to "Adjustment> Adjustment when
Replacing the Parts" in the Service Manual.
537-8001-02 a. Front Alignment Motor error b. Rear Aligning Plate HP error
Detection Description a. The Front Alignment Plate HP Sensor was not turned OFF although 1 second had passed after
the Front Alignment Motor operation started.
b. The rear aligning plate does not come off the Rear Aligning Plate HP Sensor although the Rear
Aligning Plate Motor has been driven for 4 seconds.
Remedy a. INNER FIN-G1
[Related parts]
- Harnesses and connectors from the Finisher Controller PCB to the Front Alignment Plate HP
Sensor
- Harnesses and connectors from the Finisher Controller PCB to the Front Alignment Motor
- Front Alignment Plate HP Sensor (PS4)
- Front Alignment Motor (M3)
- Finisher Controller PCB (PCB1)
b. STAPLE FIN-U1/BOOKLET FIN-U1
[Related parts]
- Harnesses and connectors from the Finisher Controller PCB to the Rear Aligning Plate HP Sensor
- Harnesses and connectors from the Finisher Controller PCB to the Rear Aligning Plate Motor
- Rear aligning plate drive mechanism
- Rear Aligning Plate HP Sensor (PI107)
- Rear Aligning Plate Motor (M104)
- Finisher Controller PCB (PCB1)
[Remedy] Check/replace the corresponding harnesses/cables or connectors or the parts.
[Reference] When replacing the Finisher Controller PCB, refer to "Adjustment> Adjustment when
Replacing the Parts" in the Service Manual.
7. Error/Jam/Alarm
560