Canon imageRUNNER ADVANCE C3330 Series, Service Manual

Page: 874 / 1225

COPIER (Service mode for copier) > OPTION (Specification setting mode) > NETWORK
WUEN-LIV 2 Set startup time after sleep notice
Detail To set the time from startup from sleep mode via network without job assignment until the mode
is shifted to the sleep mode again.
Use Case When setting the startup time after sleep notification
Adj/Set/Operate Method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/Adj/Set Range 1 to 600
Unit sec
Default Value 15
Amount of Change per
Unit
1
IFX-CHIG 1 Set operation by IFAX recv e-mail text
Detail To set the number of characters for the IFAX received e-mail text, so that the e-mail is not printed/
forwarded when the characters in the e-mail text is less than the number of specified characters.
When a sender sends e-mail text consisting of linefeed codes only, this machine outputs a blank
paper. In such case, specify 2 (number of characters) so that there will be no output of blank paper.
In the case of specifying any number other than 0, header/footer is printed/forwarded in 1 sheet
only if the e-mail text is less than the specified value while no TIFF file is attached.
As the value is incremented by 1, the number of target characters in e-mail text is increased by 1
character.
Use Case When reducing printouts of blank paper due to e-mail received by IFAX
Adj/Set/Operate Method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Caution Be sure to get approval from the user by telling that e-mail text is not printed if the number of
characters is less than the specified value.
Display/Adj/Set Range 0 to 999
0: E-mail text is not ignored.
Unit char
Default Value 0
Supplement/Memo A Japanese Kanji character is calculated as 2 bytes, and the control codes (such as linefeed code,
etc) are included in the number of characters.
Amount of Change per
Unit
1
DNSTRANS 1 Setting of DNS query priority protocol
Detail To set priority of the protocol (IPv4/IPv6) for DNS query.
In the case of using both IPv6 and IPv4 while the DNS server supports IPv4, it takes time because
of timeout when executing DNS query with priority on IPv6. Giving priority on query by IPv4 can
shorten the time.
Use Case
When it takes time to execute DNS query with priority on IPv6 because the DNS server supports
IPv4
Adj/Set/Operate Method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/Adj/Set Range 0 to 1
0: IPv4, 1: IPv6
Default Value 1
8. Service Mode
862