Canon imageRUNNER ADVANCE C3330 Series, Service Manual

Page: 885 / 1225

COPIER (Service mode for copier) > OPTION (Specification setting mode) > FEED-SW
EVLP-FS 2 Setting of fixing speed: envelope
Detail To set fixing speed when feeding envelope.
As the value is changed by 1, the fixing speed is changed by 0.1%.
Decrease the value when fine line displacement occurs on trailing edge of envelope, and increase
the value when wrinkles occur.
Use Case When fine line displacement or wrinkles occur on trailing edge while feeding envelope
Adj/Set/Operate Method Enter the setting value (switch negative/positive by -/+ key) and press OK key.
Caution Be sure to change the value a little at a time. Otherwise, fine line displacement/wrinkles occur
when setting an extreme value.
Display/Adj/Set Range -20 to 20
Unit %
Default Value 0
Related Service Mode COPIER> OPTION> FEED-SW> EVLP-SPD
Amount of Change per
Unit
0.1
■ IMG-SPD
COPIER (Service mode for copier) > OPTION (Specification setting mode) > IMG-SPD
FX-D-TMP 1 Set small paper down sequence start temp
Detail To set temperature to start the down sequence control to small size paper (length in width direction
is less than that of A4R).
When a negative value is entered, the temperature is decreased by 5 deg C from the initial setting
temperature. When a positive value is entered, it is increased by 2 deg C (upper limit is 273 deg
C).
Use Case When alleviating fixing offset on the edge of paper and improving productivity
Adj/Set/Operate Method 1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Turn OFF/ON the main power switch.
Display/Adj/Set Range -4 to 4
-4: -20 deg C, -3: -15 deg C, -2: -10 deg C, -1: -5 deg C, 0: 0 deg C, 1: 2 deg C, 2: 4 deg C, 3: 6
deg C, 4: 8 deg C
Unit deg C
Default Value 0
FIX-ROT 1 Set idle rotn stop temp after s-ppr feed
Detail Temperature on the edges of the Fixing Film becomes higher than the temperature at the center
when feeding large size paper after small size paper through the Fixing Unit. Idle rotation is
executed until temperature is decreased to the specified value after feeding small size paper to
prevent occurrence of fixing offset or wrinkles.
To set the temperature that is the condition to stop idle rotation.
As the value is larger, temperature is decreased. Image quality can be improved, but downtime is
increased.
When the value is decreased, downtime is decreased, but uneven gloss may occur.
Use Case When alleviating fixing offset/uneven gloss on the paper edge or improving productivity
Adj/Set/Operate Method 1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Turn OFF/ON the main power switch.
Display/Adj/Set Range
-2 to 2
-2: +10 deg C, -1: +5 deg C, 0: 0 deg C, 1: -5 deg C, 2: -10 deg C
Unit
deg C
Default Value
0
Amount of Change per
Unit
5
8. Service Mode
873