Canon imageRUNNER ADVANCE C3330 Series, Service Manual

Page: 566 / 1225

500-0000-02 Communication error
Detection Description A communication error between the host machine and the Finisher was detected.
Remedy
[Related parts]
- Harnesses and connectors from the DC Controller PCB to the Finisher Controller PCB
- Finisher Controller PCB (PCB1)
- DC Controller PCB
[Remedy] Perform the following in the order while checking whether the error is cleared.
1. Check/replace the harness and connector between the DC Controller PCB and the Finisher
Controller PCB.
2. Replace the Finisher Controller PCB.
[Reference] When replacing the Finisher Controller PCB, refer to "Adjustment> Adjustment when
Replacing the Parts" in the Service Manual.
3. Replace the DC Controller PCB.
[Reference] Before replacing the DC Controller PCB, back up the service mode data and restore
the backup data after the replacement so the data may be able to be protected.
- Backup: COPIER (LEVEL2)> FUNCTION> SYSTEM> DSRAMBUP
- Restoration: COPIER (LEVEL2)> FUNCTION> SYSTEM> DSRAMRES
501-0091-02 Communication error
Detection Description A communication error between the Finisher and the Buffer Pass was detected.
Remedy STAPLE FIN-U1/BOOKLET FIN-U1
[Related parts]
- Harnesses and connectors from the Buffer Pass Controller PCB to the Finisher Controller PCB
- Buffer Pass Controller PCB (PCB201)
- Finisher Controller PCB (PCB1)
[Remedy] Perform the following in the order while checking whether the error is cleared.
1. Check/replace the harness and connector between the Buffer Pass Controller PCB and the
Finisher Controller PCB.
2. Replace the Buffer Pass Controller PCB.
3. Replace the Finisher Controller PCB.
[Reference] When replacing the Finisher Controller PCB, refer to "Adjustment> Adjustment when
Replacing the Parts" in the Service Manual.
503-0002-02 Communication error
Detection Description A communication error between the Finisher Controller PCB and the Saddle Stitcher Controller
PCB was detected.
Remedy STAPLE FIN-U1/BOOKLET FIN-U1
[Related parts]
- Harnesses and connectors from the Finisher Controller PCB to the Saddle Stitcher Controller
PCB
- Finisher Controller PCB (PCB1)
- Saddle Stitcher Controller PCB (PCB2)
[Remedy] Perform the following in the order while checking whether the error is cleared.
1. Check/replace the harness and connector between the Finisher Controller PCB and the Saddle
Stitcher Controller PCB.
2. Replace the Finisher Controller PCB.
[Reference] When replacing the Finisher Controller PCB, refer to "Adjustment> Adjustment when
Replacing the Parts" in the Service Manual.
3. Replace the Saddle Stitcher Controller PCB.
505-0001-02 Error in EEPROM of the Finisher
Detection Description An error was detected in the check sum value of data read from EEPROM on the Finisher Controller
PCB.
Remedy [Related parts] Finisher Controller PCB (PCB1)
[Remedy] Check/replace the Finisher Controller PCB (PCB1).
[Reference] Before replacing the Finisher Controller PCB, back up the service mode data and
restore the backup data after the replacement so the data may be able to be protected.
- Backup: SORTER (LEVEL1)> FUNCTION> SYSTEM> FIN-BK-R
- Restoration: SORTER (LEVEL1)> FUNCTION> SYSTEM> FIN-BK-W
7. Error/Jam/Alarm
554