Canon imageRUNNER ADVANCE C3330 Series, Service Manual

Page: 902 / 1225

COPIER (Service mode for copier) > OPTION (Specification setting mode) > IMG-FIX
FXST2-UH 1 Set ITOP wait time:below 10 deg C,1/2SPD
Detail To set initial rotation time at 1/2 speed when a temperature is lower than 10 deg C.
Increase the value when a fixing failure occurs.
Use Case When fixing failure occurs in an environment where a temperature is lower than 10 deg C
Adj/Set/Operate Method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/Adj/Set Range 0 to 30
Unit sec
Default Value 0
Supplement/Memo In any of the following cases, it becomes 1/2 speed.
- Paper type: Heavy paper 1/2/3/4, 1-sided coated paper 1/2/3, 2-sided coated paper 1/2/3,
transparency, label, bond paper, postcard/4 on 1 postcard, or envelope
- Resolution: 1200 dpi
- Paper width: 300.0 mm or more
Amount of Change per
Unit
1
FLYING 2 ON/OFF of flying start temperature ctrl
Detail To set whether to execute flying start temperature control.
When 1 is set, flying start temperature control is not performed. Selecting 1 has an advantage over
selecting 0 in terms of the life of the Fixing Unit. However, selecting 1 does not always extend the
life.
Use Case When preferring to extend the life of the Fixing Unit
Adj/Set/Operate Method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Caution When 1 is set, FCOT becomes longer.
Display/Adj/Set Range 0 to 1
0: ON, 1: OFF
Default Value 0
TMP-TBL7 1 Set fix ctrl temp:pln2,color,trace,punch
Detail To set the offset of fixing control temperature for plain paper 2 (76 to 90 g/m2), colored paper,
tracing paper and pre-punched paper.
As the value is changed by 1, the control temperature is changed by 5 deg C.
Increase the value when a fixing failure occurs, and decrease the value when fixing offset occurs.
Use Case When a fixing failure/fixing offset occurs on plain paper 2, colored paper, tracing paper and pre-
punched paper
Adj/Set/Operate Method Enter the setting value (switch negative/positive by -/+ key) and press OK key.
Display/Adj/Set Range -2 to 2
-2: -10 deg C, -1: -5 deg C, 0: 0 deg C, 1: +5 deg C, 2: +10 deg C
Unit
deg C
Default Value
0
Amount of Change per
Unit
5
8. Service Mode
890