Canon imageRUNNER ADVANCE C3330 Series, Service Manual

Page: 814 / 1225

COPIER (Service mode for copier) > ADJUST (Adjustment mode) > FEED-ADJ
LP-DUP2 1 Adj pre-rgst arch amount: heavy, 2-sided
Detail To adjust the arch amount before registration for paper belonging to a group of heavy papers fed
in 2-sided mode.
As the value is changed by 1, the arch amount is changed by 0.1 mm.
+: Increase
-: Decrease
Use Case When an image on the 2nd side of paper belonging to a group of heavy papers fed in 2-sided mode
is skewed
Adj/Set/Operate Method Enter the setting value (switch negative/positive by -/+ key) and press OK key.
Display/Adj/Set Range -50 to 50
Unit mm
Default Value 0
Supplement/Memo Group of heavy papers: Heavy paper 1/2/3/4, coated paper 1/2/3, transparency, label, bond paper,
envelope, postcard
Amount of Change per
Unit
0.1
REG-SPD 1 Adjustment of Registration Motor speed
Detail To adjust the speed of the Registration Motor.
As the value is changed by 1, the speed is changed by 0.2%.
+: Increase
-: Decrease
As the value is reduced, blur image in the area of 60 to 70 mm from the trailing edge is alleviated.
Use Case When blur image occurs in the area of 60 to 70 mm from the trailing edge
Adj/Set/Operate Method Enter the setting value (switch negative/positive by -/+ key) and press OK key.
Display/Adj/Set Range -5 to 5
Unit %
Default Value 0
Amount of Change per
Unit
0.2
EXT-SPD 2 Setting of delivery speed at 1/1 speed
Detail To set the delivery speed of papers (thin paper 1, plain paper 1/2/3, colored paper 1, recycled
paper 1/2/3, pre-punched paper 1 and tracing paper) which are fed at 1/1 speed in the case of
delivering to the First/Second Delivery Tray.
Set 2 if misalignment occurs with the papers when delivering to the First Delivery Tray. Speed of
the Fixing Motor is reduced so that papers are stacked on the First Delivery Tray more gently.
Set 1 if trailing edges of papers with 297 mm (A4R) or less in length get caught on the delivery
outlet when delivering to the Second Delivery Tray. Speed of the Second Delivery Motor is
increased so that trailing edge of paper can pass through the delivery outlet.
Set 3 if both of the above symptoms occur.
Use Case
- When misalignment occurs at delivery to the First Delivery Tray
- When trailing edge of paper get caught on the delivery outlet at delivery to the Second Delivery
Tray
Adj/Set/Operate Method
Enter the setting value, and then press OK key.
Caution When 2 or 3 is set, FCOT becomes longer.
Display/Adj/Set Range 0 to 3
0: Normal, 1: Increase the speed at delivery to the Second Delivery Tray, 2: Reduce the speed at
delivery to the First Delivery Tray, 3: Reduce the speed at delivery to the First Delivery Tray and
increase the speed at delivery to the Second Delivery Tray
Default Value 0
8. Service Mode
802