Canon imageRUNNER ADVANCE C3330 Series, Service Manual

Page: 862 / 1225

COPIER (Service mode for copier) > OPTION (Specification setting mode) > FNC-SW
CST-MDL 2 Set number of cassettes of the machine
Detail To set whether to configure the machine as 1-cassette machine.
When 1 is set, only the Cassette 2 can be used.
Use Case - When configuring the number of cassettes for the 1-cassette model for China as 1-cassette
- When executing MN-CON
- When replacing the HDD
Adj/Set/Operate Method 1) Turn OFF the main power switch.
2) Remove the Cassette 1.
3) Turn ON the main power switch.
4) Enter 1, and then press OK key.
5) Turn OFF/ON the main power switch.
Caution Do not use this mode for models other than the 1-cassette model for China.
Display/Adj/Set Range 0 to 1
0: 2-cassette configuration (normal), 1: 1-cassette configuration (for China)
Default Value 0
Related Service Mode COPIER> FUNCTION> CLEAR> MN-CON
Supplement/Memo Procedure to configure the machine as 2-cassette machine
1) Turn OFF the main power switch.
2) Install the Cassette 1.
3) Turn ON the main power switch.
4) Enter 0, and then press OK key.
5) Turn OFF/ON the main power switch.
CE-SW 1 [Reserve]
INTR-TML 2 Set ini rtn time: extra-long size ppr fd
Detail To set the offset of initial rotation time when feeding extra-long size paper.
When the result is a negative value, the time becomes "0 second".
Increase the value when a fixing failure occurs on the edge, and decrease the value when
prioritizing productivity.
Use Case - When a fixing failure occurs on the edge while feeding extra-long size paper
- When reducing downtime
Adj/Set/Operate Method Enter the setting value (switch negative/positive by -/+ key) and press OK key.
Caution As the value is larger, FCOT becomes longer.
If the value is too small, a fixing failure may occur on the edge.
Display/Adj/Set Range -2 to 2
-2: -15 seconds, -1: -10 seconds, 0: 0 second, 1: +5 seconds, 2: +10 seconds
Unit sec
Default Value 0
PREXP-SW 2 Set Clean Pre-exposure LED light condtn
Detail To set the condition to light up the Cleaning Pre-exposure LED.
When drum ghost occurs, set 1. If it is not alleviated, set 2.
Use Case
When drum ghost occurs
Adj/Set/Operate Method Enter the setting value, and then press OK key.
Caution When 1 or 2 is set, horizontal lines due to charging may appear earlier.
Display/Adj/Set Range 0 to 3
0: Light up according to image information
1: Light up regardless of image information
2: Light up regardless of image information and light intensity is increased
3: For R&D use
Default Value 0
Related Service Mode COPIER> ADJUST> EXP-LED> PR-EXP-Y/M/C/K, PR-EXPY2, PR-EXPM2, PR-EXPC2, PR-
EXPK2
8. Service Mode
850