Canon imageRUNNER ADVANCE C3330 Series, Service Manual

Page: 1007 / 1225

SORTER (Service mode for delivery options) > OPTION (Specification setting mode)
STCR-DWN 1 Set occasional misalign prev mode:Fin-U1
Detail To set ON/OFF of occasional misalignment prevention mode.
When 1 is set, the rise amount of roller at the staple sort delivery of thin/plain paper by the swing
height detection control is decreased. (so the distance between the roller and paper shrinks.)
Use Case When misalignment in feed direction occurs occasionally at the staple sort delivery of thin/plain
paper
Adj/Set/Operate Method Enter the setting value, and then press OK key.
Display/Adj/Set Range 0 to 1
0: OFF, 1: ON
Default Value 0
PRCS-SP3 1 Set the feed speed to Proc Tray: Fin-U1
Detail To set the feeding speed of the paper to the Processing Tray in the staple mode.
As the value is increased by 1, the feeding speed is decelerated by 50 mm/sec.
Use Case
When misalignment (buckling on the trailing edge) occurs in staple mode owing to returning the
paper too much.
Adj/Set/Operate Method
Enter the setting value, and then press OK key.
Caution
Adjust the return amount of the paper on the Processing Tray again with PRCS-RET as needed.
Display/Adj/Set Range
0 to 8
0: 700 mm/s, 1: 650 mm/s, 2: 600 mm/s, 3: 550 mm/s, 4: 500 mm/s, 5: 450 mm/s, 6 to 8: 450 mm/
s
Unit
mm/s
Default Value 0
Related Service Mode SORTER> ADJUST> PRCS-RET
Amount of Change per
Unit
50
NSRT-STC 1 Set stck improve at non-collate: Fin-U1
Detail To set ON/OFF of stack improvement mode in non-collate mode.
When 1 or 2 is set, paper stack is delivered via the Processing Tray even if it is in non-collate mode
so the stacking condition can be improved.
Use Case When the stacking condition at non-collating is poor
Adj/Set/Operate Method Enter the setting value, and then press OK key.
Display/Adj/Set Range 0 to 2
0: Not pass through the Processing Tray, 1: Pass through the Processing Tray at 2-sided print, 2:
Pass through the Processing Tray
Default Value
1
THN-TRSW 1 Set small width ppr delvry destn: Fin-U1
Detail To set the delivery destination of paper which width direction is 139.6 mm or less.
When 1 is set, the following paper which width direction is 139.6 mm or less is delivered to the tray
of the host machine.
- Thin (52 to 63g/m2)/Plain 1 (64 to 75g/m2)/Recycled 1 (64 to 75g/m2)/Tracing (64 to 99g/m2)/
Pre-Punched (64 to 75g/m2)
Use Case When the delivery stationary jam occurs at the time of delivering small width paper to the
downstream connection equipment
Adj/Set/Operate Method Enter the setting value and press OK key.
Caution When the stack paper of the host machine's tray is full, the paper is delivered to the downstream
connection machine even if the setting is 1.
Display/Adj/Set Range 0 to 1
0: Delivery destination specified in Control Panel menu, 1: Tray of the host machine
Default Value 0
8. Service Mode
995