![background image](http://html1.mh-extra.com/html/omron/cs1w-213-rev-02-2008/cs1w-213-rev-02-2008_operation-manual_742355239.webp)
214
Linear Interpolation
Section 8-6
tinuous, the interpolation speed and the speeds of the X and Y axes are as
shown below, with the pulses being output suddenly and stopped suddenly.
Reversal in Axis
Operation
If an axis with interpolation reverses at the intermediate point when executing
linear interpolation with the completion code set to continuous (completion
code 2), all axes with interpolation will temporarily stop at the intermediate
points. When reversing the operation direction of an axis, the same period of
time will be taken for other axes with interpolation.
Acceleration/Deceleration will not occur for a temporary stop at intermediate
points. When this operation is executed, therefore, set the completion code to
automatic (completion code 1).
The following example shows the linear interpolation of the X and Y axes
starting at the X axis. At point “A” the direction of movement at the Y axis is
reversed.
In this example the interpolation speed to point “A” is given as “a,” and the
interpolation speed to point “B” is given as “b.” With a continuous completion
code, the pulse output temporarily stops at point “A” as shown below. The
stop time is approximately 8 ms.
Interpolation
speed (pps)
Completion
code:
continuous
Completion
code:
continuous
Point A
Point B
Time
X axis speed
(pps)
Sudden output of pulses
Pulse output stops
Time
Y axis speed
(pps)
Time
Sudden output of pulses
Pulse output stops
Y axis
X axis
Origin
A
B
b
a
θ
1
θ
2
Содержание CS1W-213 - REV 02-2008
