![background image](http://html1.mh-extra.com/html/omron/cs1w-213-rev-02-2008/cs1w-213-rev-02-2008_operation-manual_742355205.webp)
180
Operations With Direct Operation
Section 7-4
7-4-4
Multiple Start Operating Patterns
Operation Patterns for Absolute Movement
When a reversal is specified by the ABSOLUTE MOVEMENT command, posi-
tioning will first decelerate at the deceleration time that has been set and then
accelerate in the reverse direction at the acceleration time that has been set.
Multiple reversals may not be possible if they are generated while a reversal
operation is already being performed.
Operation Patterns for Relative Movement
If the value of the RELATIVE MOVEMENT command causes a reverse, an
emergency reverse will occur when the command is received.
Multiple Start Validity
A multiple start is intended for applications that require changing the target
position during operation. Therefore, to ensure that the multiple start is exe-
cuted, avoid activating the multiple start right before stopping. If the multiple
start is activated within 16 ms of stopping, as shown in the following figure, all
the immediately preceding position command values will be output and the
specified position will be reached. Newly specified position command values,
however, may become invalid.
Without Reversal
With Reversal
Speed
Speed
New command (CHANGE POSITION)
Start
First specified
position
New specified
position
CW position
CW position
New command (CHANGE POSITION)
Start
First specified
position
New specified position
Without Reversal
With Reversal
Speed
Speed
New command (CHANGE POSITION)
Start
First specified
position
New specified
position
CW position
CW position
New command (CHANGE POSITION)
Start
First specified
position
New specified position
Speed
Busy Flag
Time
16 ms
Multiple start will
become invalid.
ABSOLUTE MOVEMENT
command/RELATIVE
MOVEMENT command
Содержание CS1W-213 - REV 02-2008
