![background image](http://html1.mh-extra.com/html/omron/cs1w-213-rev-02-2008/cs1w-213-rev-02-2008_operation-manual_742355095.webp)
70
Common Parameter Area
Section 4-2
4-2-1
Outline
Memory from the area allocated to Special I/O Units in the CPU Unit’s DM
Area is allocated to the common parameters. The beginning word of the allo-
cated area is determined by the unit number set for the PCU according to the
following equation.
Beginning word of common parameter area, m = 100
×
unit num-
ber.
After the common parameter settings have been made, they will go into effect
the next time the PCU is powered up or restarted.
The settings for the common parameters are explained below.
4-2-2
Details
The details of the common parameters settings are given below.
Designation and Beginning Word of Operating Data Area
Word Address and Enable
Timing
The word addresses and enable timing for the beginning word of operating
data area and operating data area designation settings are shown below.
Bit Configuration
The bit configurations for the word addresses in the above table are shown
below.
Word
(same for all models)
Name
Configuration/Explanation
Page
m
Operating data area designation
Designate the memory area to which the
operating data is to be set. Select one
from the following.
0000: DM Area words allocated to Spe-
cial I/O Units (fixed)
000D: User-specified DM Area words
0X0E: User-specified EM Area words (X:
bank number)
70
m+1
Beginning word of operating data area
Designate the beginning word of the
operating data area. If 000D (user-speci-
fied DM Area words) or 0X0E (user-spec-
ified EM Area words) is set for the
operating data area designation, specify
the beginning word of the area to be allo-
cated as the operating data area in hexa-
decimal.
m+2
Axis parameter designation
Designate the location of the data to be
used as axis parameters. Select one from
the following.
• Axis parameter data saved in the
PCU’s flash memory.
• Axis parameter data set in the CPU
Unit’s DM Area.
• PCU’s default setting.
• Settings for unused axes (supported
on PCUs with unit version 2.1 or later).
70
m+3
Not used
This area is not used. Leave set to 0000.
72
Word
Name
Enable timing
NC1
@
3
NC2
@
3
NC4
@
3
m
Operating data area des-
ignation
At power up or restart
m+1
Beginning word of oper-
ating data area
Содержание CS1W-213 - REV 02-2008
