Omron CS1W-213 - REV 02-2008, Руководство по эксплуатации

Страница: 68 / 401

43
Wiring Section 3-4
Origin Input Signal (24 V)
Origin Input Signal (5 V) (Line Driver Input)
Positioning Completed
Input Signal The positioning completed input signal is also used as an origin search com-
pleted signal in modes 2 and 3. Adjust the setting of the Servo Drive so that
this signal always turns off while the servomotor is operating, and on when the
motor is stopped.
An origin search operation cannot be completed unless the positioning com-
pleted input signal turns ON after positioning has been completed.
3-4-4 Wiring Precautions
Operational errors such as dislocation can occur in most electronic control
devices if they are subjected to electronic noise from nearby power lines or
loads. Recovery from such errors is usually very difficult and time consuming.
Example:
OMRON E2R-A01 Proximity
Sensor (NPN output type)
Position Control Unit
24-VDC power
supply
150 Ω
4.7 k Ω
680 Ω
+v
0 V
+ –
Signal
Switch
circuitry
A15/B15
A14/B14
Position Control Unit
OMRON R88D-GT
24
4.7 k
Ω
150
Ω
680
Ω
A16/B16
A14/B14
23
+z
–z
Servo Drive
Position Control Unit
24-VDC
power supply
4.7 k
Ω
(1/2W)
680
Ω
A12/B12
+
OMRON R88D-GT
–
38
39
INP
A1/B1
INPCOM
Servo Drive