3-4 System Preparation
No.
Check Item
7
The exam date and time are the same as the system date and time, and are displayed
correctly.
WARNING:
1.
The patient may get burnt if using an excessive heated probe.
2.
The system is defective if any malfunctioning happens. In this case,
shut down the system immediately and contact Mindray Customer
Service Department or sales representative.
NOTE:
If there is over loading to the system, the breaker will switch into OFF to discontinue the power
supply.
If the breaker can’t be set as On, or returns to OFF after being switched on, please
disconnect the power cables, and contact your sales representative.
3.2.4
Powering off the System
You need to follow the correct procedures to power off the system. In addition, after you upgrade the
software or when the system is down, you need to power off and restart it.
To power off your system normally
Press the power button on left of the touch panel to see the option:
Shut down: To power off the system normally.
Standby: To enter standby status.
Cancel: To cancel the operation.
If you will not use the system for a long period of time, you should turn off the circuit breaker and
disconnect the power to all other peripheral devices.
NOTE:
Do not turn off the breaker while the power indicator is on. Otherwise, the data may lose or
the system software may be damaged.
To shut down the system in a direct way if you cannot do it normally:
Directly turn off the circuit breaker or unplug the power cord.
NOTE:
1.
DO NOT rush shutdown of the system or switch off the breaker in a direct way. It may
make the data corrupted. DO NOT directly shut down the system. It may make the data
corrupted.
2.
After the system is upgraded, using “Shut Down” to power off the system to make the
upgraded data effective.
3.2.5
Standby
To enter standby:
Open [Setup]
[System]
[General] to set the time for screensaver and standby. The system
goes into the screen saving status if without the operating. The system then goes into the
standby status if without the operation during expiring the standby time.
