6-2 Display & Cine Review
2. ROI adjustment: press <Set> to switch between size and position status; roll the trackball to change
the size/position.You can also change ROI size by rotating <Zoom>.
3. Press <Zoom>/<Update> to enter magnification status and ROI area is displayed in full screen.
4. Image-in-image displays in bottom-right part of the screen. Roll the trackball to change ROI position
and the screen image displays accordingly.
5. Rotate <Zoom> to change the magnification factor. Or enter mapping-mode and use two-finger
gesture to change the magnification factor.
6. Press <Zoom> again to exit magnification.
6.2.2
Pan Zoom
To use the function, use the <Zoom> knob on the control panel.
1. Rotate the <Zoom> knob to directly enter the pan zoom status. Or enter the touch screen mapping
mode, and zoom the image by pinching the two fingers on the touch screen. Image-in-image is
displayed.
2. Magnification factor adjustment: rotate the [Zoom] knob or pinch two fingers under mapping mode to
change the magnification factor. The image magnification factor value will display in real time in the
image parameter area. For example,
indicates that the magnification factor is 1.3.
3. Shifting the image: roll the trackball or touch and translate the image.
4. Press <Zoom> to exit pan zoom.
6.2.3
iZoom (Full-screen Zooming)
Function: to magnify the image in full screen.
Procedures:
1. Press <F8> to zoom in the image; the zooming area includes image area, parameter area, image
banner, thumbnail area and so on.
2. Press <F8> again to zoom in the image area only. The image goes to full-screen.
3. Press <F8> again to exit.
6.3
Freeze/Unfreeze the Image.
Press <Freeze> on the control panel to freeze a scanning image.In freezing mode, the probe stops
transmitting acoustic power, and all images as well as the parameters are kept still.
Tip: after freezing an image, the system may enter cine review, measure, comment adding, or body mark
mode, which is dependent upon preset. (Setting path: [Setup]
[System]
[Image]
"Freeze Config")
Press <Freeze> in frozen mode to unfreeze the image, and the system continues image scanning.
6.3.1
Imaging Mode Switching When Frozen
Imaging mode switching in frozen mode follows the following principles:
In splitting display B mode, press <Dual>/<Quad> to switch among the windows; toggle down
<3D> to exit splitting display mode and enter the image of the currently activated window in full
screen.
In frozen mode, the system supports imaging mode switching between the sub-modes (only for
the activated window). For example, if the frozen image is of B+C+PW mode, then the system
supports imaging mode switching between B+C+PW, B+C, B+PW and B by pressing <C> or <PW>.
The imaging mode and parameters of an unfrozen image is the same as the corresponding one
that before frozen; but the display format is the same as the one before unfrozen.
