MUTOH ValueJet VJ-1324, Maintenance Manual, Page: 365 / 439

5.12.8 General Endurance Menu P.5-79
5.12 Endurance Running Menu VJ1324E-M-02
5.12.8 General Endurance Menu
This menu is used to perform endurance running on the CR line (CR motor Assy , Bearing, Tube, etc)
and PF line (PR motor Assy , etc) simultaneously.
The available settings are shown below.
T I P
• In the general endurance menu, the following operations are performed as one cycle of
endurance running:
The counter indicates above-mentioned set number, and the count number counts the
same value as the only CR motor assemby endurance, etc.
• Carriage stroking: 1 stroke
• Media feed: 1 cycle
• If the number of endurance running cycles is set to -1, Carriage continuously repeats
stroking until it is canceled from Operation panel.
• The maximum counter value for endurance running cycles is 99999999 (up to 8-digit
number). If the number of cycles exceeds the maximum value, the counter displays
99999999.
Set item Contents Set value Remark
Running speed
(CW, CCW) Set Carriage running speed
(CW direction, CCW
direction).
320 、 400 、 420 Unit ： cps
Media feed
amount Set the media feed amount
per endurance running cycle. 0.1 to 100 Unit: mm
Number of
endurance running
cycles Set the number of endurance
running cycles. -1 to 10000 -
CW-speed
CCW-speed
Media feed amount
Endurance count
[Enter]
[Enter]
[Enter]
[Enter]
[Enter] or [Cancel]
Performing endurance running
[Enter]
[Enter]
[Cancel]
[Cancel]
[Cancel]
[Cancel]
㧯㨔㨑㨏㨗㧥㧦㧱㨚㨐㨡㨞㨍㨚㨏㨑
Change the values by
ޟ㧗ޠ㧛ޟ㧙ޠ key
㧯㨔㨑㨏㨗㧤㧦㨀㨛㨠㨍㨘ޓ㧸㨕㨒㨑