MUTOH ValueJet VJ-1324, Maintenance Manual, Page: 361 / 439

5.12.4 Pump Endurance Menu P.5-75
5.12 Endurance Running Menu VJ1324E-M-02
5.12.4 Pump Endurance Menu
This menu is used to perform endurance running for Pump motor Assy .
You can drive Pump motor Assy according to your desired settings.
The available settings are shown below.
T I P
• If the number of endurance running cycles is set to -1, Pump motor Assy continuously
repeats endurance running until cancel input is given from Operation panel.
• The maximum counter value for endurance running cycles is 99999999 (up to 8-digit
number). If the number of cycles exceeds the maximum value, the counter displays
99999999.
Pump motor Assy endurance running sequence is as follows.
1. Pump motor Assy endurance running starts.
2. Pump phase detection is performed.
3. Rotates at the specified suction speed. This rotation is counted as one cycle.
Step 2 above is repeated the number of times specified as follows:
Super high
: 4000 step
High : 3000 step
Normal : 2000 step
Low : 1000 step
4. Pump release is performed.
5. Pump motor Assy endurance running ends.
Set item Contents Set value
Running speed Set the running speed of Pump
motor Assy . Super high / High / Normal /
Low
Number of endurance running
cycles Set the number of endurance
running cycles. -1 to 10000
=?-G[
=?-G[
=?-G[
=?-G[
= ?-G[
= ?-G[
= ?-G[
= ?-G[
㧸㨕㨒㨑㧯㨛㨡㨚㨠㧦ޓޓޓޓޓޓޓޓ㧡㧜
㧯㨛㨡㨚㨠㧦ޓޓޓޓޓޓޓޓޓޓޓޓ㧝㧜
='PVGT?
㧱㨚㨐㧦ޓޓޓޓޓޓޓޓޓޓޓޓޓޓ㧡㧜
='PVGT?
='PVGT?
='PVGT?
='PVGT?
㧼㨡㨙㨜㧦㧿㨡㨜㨑㨞㧴㨕㨓㨔
㧸㨕㨒㨑㧠㧦㧼㨡㨙㨜
㧯㨔㨑㨏㨗㧥㧦㧱㨚㨐㨡㨞㨍㨚㨏㨑
㧼㨡㨙㨜㧦㧺㨛㨞㨙㨍㨘
㧼㨡㨙㨜㧦㧸㨛㨣
㧼㨡㨙㨜㧦㧴㨕㨓㨔
='PVGT?
='PVGT?
[Enter]
ޓ or
[Cancel]
Change the value (unit to count) by pressing
[setting/value+] or [setting/value-] key.
Endurance Count
Performing endurance
Completing endurance or [Cancel]