MUTOH ValueJet VJ-1324, Maintenance Manual, Page: 277 / 439

4.7.2 Head Alignment (Vertical Slant) P.4-14
4.7 Head Accuracy Adjustment VJ1324E-M-02
3. Refer to Appendix B to check the print result.
4. Loosen the screw retaining Head base mounting plate, refer to the above (1), (2), and (3) to adjust.
① ： No need to adjust.
② ：
Move the vertical-slant adjusting tab to the right.
③ ：
Move the vertical-slant adjusting tab to the left.
5.
Print the adjustment patterns again to check whether head slant (vertical slant) is
adjusted properly.
"5.7.5 Head Slant Check Menu" p.5-37
6.
If the head is still NOT aligned, repeat the steps 2 to 4.
7. When the operation is completed, tighten the screw that was loosened in the step 4, and install
Carriage cover.
㧮
Appendix
Media feed by
1/360 inch
1/360
㩷㫀㫅㪺㪿
1/180 㩷㫀㫅㪺㪿
㪚㪮㩷㪧㫉㫀㫅㫋
䌃䌃㪮㩷㪧㫉㫀㫅㫋㩷
iv) Enlarged joint points (Black)
Check with these
joint points
iii) Print with A, C, E, and G (CCW direction) (overlaps with the pattern of i by 1 dot)
ii) Feeds the media by 1/360 inch
i) Print with A, C, E, and G (CW direction)
Details of the vertical pattern
No. Name
1
Vertical-slant adjusting tab
2
Vertical-slant adjusting tab screw
#RRGPFKZ
㧮
Adjust so that the joint points are in line.
Ԛ
ԙ
Ԙ
٤
˜
˜
2
1