MUTOH ValueJet VJ-1324, Maintenance Manual, Page: 273 / 439

4.5.1 Adjustment Procedure P.4-10
4.6 CR Belt Tension Adjustment VJ1324E-M-02
4.6 CR Belt Tension Adjustment
This section describes the procedure to adjust the tension of the CR belt.
When you have removed and installed the CR belt, adjust the CR belt tension.
1.
Tighten the CR tension mounting shaft, and align the left side (viewed from the
front of the printer) of the graduation alignment pointer with the center line of
graduations on the driven pulley base.
NOTE
To align the graduation alignment pointer with the center line of driven
pulley base, align the left side (viewed from the front of the printer) of the
pointer with the center line as shown below.
2.
After adjustment, apply screw-locking agent to the screw head of the CR tension
mounting shaft not to loosen it.
No. Name
1 Driven pulley base
2 Driven pulley base graduations
3 Graduation alignment pointer
4 CR tension mounting shaft
1
2 3
4
No. Name
1 Driven pulley base graduations
2
CR tension mounting shaft screw head
Align them like this.
Alignment pointer
Alignment pointer
L side
R side
1
2