MUTOH ValueJet VJ-1324, Maintenance Manual, Page: 325 / 439

5.7.5 Head Slant Check Menu P.5-39
5.7 Adjustment Menu VJ1324E-M-02
(1-b)Check the vertical direction
T I P
• From the media origin side, each path is printed in the order of shown below.
Nozzle lines A/C/E/G
• CW/CCW direction printing.
Check if Head is slanted in a horizontal direction from the print result.
Follow the procedure below and check the head slant.
1. Check the print result of the head slant confirmation pattern. The items to check are as follows.
• Head slant
2. Refer to Appendix B to check the print result.
① ： No adjustment required.
② ：
Move the vertical-slant adjusting tab to the right.
③ ： Move the vertical-slant adjusting tab to the left.
"4.7.2 Head Alignment (Vertical Slant)" p.4-13
3. After adjusting Head base mounting plate,confirmation pattern again.
4. If Head slant is still not adjusted, repeat printing and adjusting.
㧮
Appendix
Media feed by
1/360 inch
1/360
㩷㫀㫅㪺㪿
1/180
㩷㫀㫅㪺㪿
㪚㪮㩷㪧㫉㫀㫅㫋
䌃䌃㪮㩷㪧㫉㫀㫅㫋㩷
iv) Enlarged joint points (Black)
Check with these
joint points
iii) Print with A, C, E, and G (CCW direction) (overlaps with the pattern of i by 1 dot)
ii) Feeds the media by 1/360 inch
i) Print with A, C, E, and G (CW direction)
Details of the vertical pattern
#RRGPFKZ
㧮
Adjust so that the joint points are in line.
Ԛ
ԙ
Ԙ
٤
˜
˜